Thanks for Sharing, John…

I never would have attempted this project without your inspiration and encouragement through the Router Workshop series.  It is a Ming side table I built for my wife as a bed-table to rest meals and “stuff” on

The wood is from a Douglas fir construction cutoff at a construction site near my home which I got for free! It was 12×4x40.  Every part of the table except for the inner tray was made from that single cutoff.  The legs were shaped by a using my router with a template I made from the original illustration of the table.

The leg joinery is mitered mortise and tenon. The top piece is attached by tenons in the vertical section of the legs and mortises in the tray. The tray has mitered through tenons wedged.  The tray is made from a quarter inch piece of plywood slid into a groove in the edge pieces at a higher elevation than the tenons.  This tray is supported by two dovetail clamps in the bottom of the tray which fit into mortises on the side pieces.  The finish is lacquer.

Thank you for your inspiration to “get out my router”.

John Stark

Listen to John and get your router out of the box…Join NOW, only 100 spots left.

We are running an end of summer sale and have the cost of the online video set at 70% off. This coupon code gives a charge for the first month of $5.99 plus the reoccurring charge of $2.98. The coupon number is 8C6224192A, which has a expiry date set at 1) the first 200 people or 2) October 15th, 2010, which ever comes first. If you were interested in joining the Router Workshop then this is the time…Click here to join.

End of Summer…

Well the summer is just about over and your holidays are now behind you. As you remember my deal on the online video has been set at $10.00 plus $4.00 per month recurring billing for the full library of 183 episodes.

Today I have changed how we determine the cost of the Router Workshop video series for both the online version and the offline High Resolution version.

The Online Version:

The standard charge is going back to $19.95 for the first month plus $9.95 per month for four new episodes per month, which is approximately $2.48 per episode. Any deals for the future will be given as coupon codes like the ones below.

End of summer sale, coupon code 8C6224192A

We are running an end of summer sale and have the cost of the online video set at 70% off. This coupon code gives a charge for the first month of $5.99 plus the reoccurring charge of $2.98. The coupon number is 8C6224192A, which has a expiry date set at 1) the first 200 people or 2) October 15th, 2010, which ever comes first. If you were interested in joining the Router Workshop then this is the time…Click here to join.

What is up folks??

Just a short reminder about the “exercise for router enthusiasts.” This challenge is made for everybody that uses a router in the workshop. If you are a beginner then this is a excellent practice exercise that will serve you well throughout your journey of mastering the router.

For the Intermediate and advanced users I see this practice session as a way to show the others the well learned lessons that you have acquired over the years. The action of changing router bits and making a set up is the most fundamental operation and something that everybody should have a good handle doing.

I assume with the lack of response to both my post and my front page is that maybe the challenge might be to hard? The reason for this post is hopefully to get some kid of discussion going through the comments section. So please leave you opinion about the challenge at this post whether it be negative or positive.

Here is a link to the post that I want to discuss.

You can also see the topic on my front page.